Thick-Oil Setup for Packman Christmas Edition 2g (Empty)

Winter blends need stable heat and good intake. Here’s a fast setup that works for most heavy formulations—and how to validate it in minutes.

Pre-Heat & Voltage Habits

Teach 5-click on/off and 2-click pre-heat on screen models. Pre-heat stabilizes viscosity and cuts cold-start sputter. For daily use, advise short primer presses rather than long burns.

Coil & Intake Pairing

A common baseline is 1.4 Ω ceramic with 4 ports around 1.6–1.8 mm. If your oil is very dense at 20–22 °C, test the larger end of that intake window and monitor first-puff saturation at 5–10 °C.

USB-C & Battery Expectations

Screen variants in this class usually quote ~320–350 mAh and USB-C charging. Heavier pre-heat use or cold temperatures benefit from higher-mAh bins—note this in your PO if available.

Three Fast QC Checks

1. Leak test: Weigh before/after a 3-minute warm cycle; delta within your tolerance.
2. Screen & controls: 5-click power and 2-click pre-heat work; battery icon updates after a 10–20 s draw.
3. Port fit: Insert a USB-C plug five times; reject wobble/intermittent contact.

Hardware only. ExtractsVape supplies empty devices—no oil.